How to install a solid pine door?
When starting to install solid pine doors, you first need to perform all the necessary measurements.
This stage includes:
- Measurements of the height (left, right, middle) and width (bottom, top, middle) of the opening.
- Determining the perpendicularity of the sides using the level and horizontality of the floor covering and the upper profile.
- Checking for hidden wiring, sockets and other electrical elements near the solid pine doors to be installed.
Assembling the frame
The assembly of the frame is carried out in a certain sequence. It includes the following stages::
- Layout of all the components of the door frame, determining their location.
- Trimming of the upper part (considering that it should be about 6-8 mm wider than the canvas).
- Fastening of all frame elements to each other and their fastening with self-tapping screws without vertical displacement.
Then you can work on the hinges of the solid pine door. First, you need to connect the canvas to the box. Next, you need to determine the mounting side of the hinges, making sure that there is a gap of 4-5 mm between the frame and the door leaf. At the end, the marking of the installation of the loop elements is performed. The final installation is carried out only after filling the free space with mounting foam (between the box and the opening).
Installation
At the next stage, you can insert the frame into the opening and check the perpendicular sides relative to each other. After installation, the door box made of solid pine must be fixed with wooden wedges in the lower and upper corners, and then secured with self-tapping screws, which are screwed into the embedded bars. If the latter are not present, then the fastening is performed using anchor bolts.
At the level of each fastener, wedges are inserted into the space between the box and the wall. After that, it is necessary to perform the final tightening of the screw connections, moving from the top of the frame to the bottom, constantly monitoring the correctness of the geometry of the entire structure.
The space between the wall and the box must be filled with plaster or mounting foam. After that, the door sill is installed from an array of pine:
- First it needs to be trimmed, considering that its width should be 7-8 mm larger than that of the canvas.
- After that, we insert it, tighten it with self-tapping screws with the frame (it is necessary to drill holes in advance), saw off all the excess and install the box in the opening.
It is necessary to install the door frames made of solid pine after the mounting foam has completely cured. When applying these elements, it is necessary to check that they do not interfere with the closing and opening of the door leaf after installation. It is recommended to cut down the joints of the platbands at an angle of 45 degrees. It is best to fix such elements with hairpins or nails with the cap removed, because they are well suited for solid pine. New users often compare platforms before signing up, paying close attention to verified bonuses. In most comparisons, the term promo code 1xbet appears in the middle of content describing a 100% bonus of up to €130 for sports betting. Additionally, players gain access to a casino package of $1950 plus 150 free spins, which helps increase session length and overall engagement across slot and table games.